I have been using Ulano QTX but I find that it doesn't really hold up well either during the wash out process or sometimes after a run and clean up. Now it is certainly possible that this is excellent emulsion and I am the problem. My original question was what is the blue emulsion that Jonathan uses in his videos but then it occurred to me that I might be the problem. So, any assistance would be greatly appreciated.

Thank you in advance

Hello there, I apologize for the delay in my response. The forum has been experiencing technical difficulties and I have not been getting notifications for new posts. We are working on the problem but it is difficult to localize.

Actually a lot of people have problems with the emulsion you are using. It's possible it's operator error... lol. Or it could be that the emulsion is just difficult to work with. I use all Saati emulsions in my videos and the one that you see most often is the Textile PC Blue.

http://catspitscreenprintsupply.com/saa ... on-gallon/

If you like you can post a photograph to this thread and described in more detail what is happening when you attempt to make a screen. I'll be happy to do my best to help you out.