Pressing issue w/ Single Step Laser Weed-Less Paper
Posted: Fri May 30, 2014 9:00 am
So I am just starting off with using the Single Step Laser Weed-Less Paper (and a Heat Press) and for the most part I am getting some good results, but I know that it could be better with some guidance from the forum. So I am hoping that someone here can possible advise me.
I printed all my images out with a good Color Laser Printer (mirrored) them and let it completely dry and I followed the directions that were included and also watched your video as well. So my white cotton shirts were almost successful BUT I continue to have the same issues:
1. I noticed that after I let it cool for 10 seconds and pulled it off, there was a clear film like residue that was left.
2. After I pulled off the transfer, some of the image was left on the paper and did not make it to my shirt.
I know that its probably about trial and error, but I have been going thru alot of the transfers and I dont want to keep wasting them.
Thank you in advance for any guidance.
I printed all my images out with a good Color Laser Printer (mirrored) them and let it completely dry and I followed the directions that were included and also watched your video as well. So my white cotton shirts were almost successful BUT I continue to have the same issues:
1. I noticed that after I let it cool for 10 seconds and pulled it off, there was a clear film like residue that was left.
2. After I pulled off the transfer, some of the image was left on the paper and did not make it to my shirt.
I know that its probably about trial and error, but I have been going thru alot of the transfers and I dont want to keep wasting them.
Thank you in advance for any guidance.