Hey what's up. . This is an awesome site. .alot of knowledge and I appreciate any and all help I get.
I have a graphic that I seperated in Seperation studio. It calls for a white underbase, gold and a white top for a total of 3 screens.
I was planning on printing the white underbase on a 165 mesh screen and the gold on a 230 mesh but I'm not sure what to do the top white with. .. should I use another 165?
Thanks.
printing white top (finishing Layer)
Moderators: Shamax, Leadfoot, ApeShirt, Catspit Productions
-
- Master Screen Printer
- Posts: 382
- Joined: Fri Apr 13, 2012 1:11 pm
- Location: Lansing, MI
- Contact:
Re: printing white top (finishing Layer)
Plastisol or water based? Either way, 165 could be high depending on ink and design.
Greg
If you're not going to go all the way then why bother going at all.
ApeShirt Apparel Printing, LLC
If you're not going to go all the way then why bother going at all.
ApeShirt Apparel Printing, LLC
Re: printing white top (finishing Layer)
So I decided to skip the white top and save a screen by making the white underbase whiter. Came out pretty good. Thanks for the reply though. ..I couldn't wait for answers lol
-
- Screen Trooper
- Posts: 5
- Joined: Tue Oct 20, 2015 6:16 am
Re: printing white top (finishing Layer)
Intresting