Page 1 of 1

I need suggestions please

Posted: Sun Nov 12, 2017 1:29 pm
by Meatsack
I have a ghosting problem with black waterbase in. I have a haze remover from framar and it basically does nothing. I tried bleaching the screen and it helped a little. What should I try next? I read some of the other topics and I guess besides trying lacquer thinner which some say is a no no what do I do now? Is the haze remover I have not strong enough? I let it sit for 10 mins but litteraly did nothing. Do you recommend 1 of your haze removers instead? Something that can eat the souls of children or something stronger lol. Thanks

Re: I need suggestions please

Posted: Sun Nov 12, 2017 2:30 pm
by Meatsack
Also I did try lacquer thinner and that did nothing. Scrubbed it with a tooth brush for 10 mins and nothing. I was surprised. Am I out of luck?

Re: I need suggestions please

Posted: Mon Nov 13, 2017 11:41 am
by Catspit Productions
Yes, a better haze remover may work. But if this is actual dried ink in the mesh that could be a problem. I would try Saati HR5. It's very aggressive but it should only damn the souls of children and perhaps some women. So they have a chance for redemption.

http://catspitscreenprintsupply.com/saa ... er-gallon/

http://catspitscreenprintsupply.com/saa ... ver-quart/

Re: I need suggestions please

Posted: Mon Nov 13, 2017 12:44 pm
by Meatsack
It's not actually dried in the mesh holes themselves. I can still print through it. It's just the treads there are really black and dyed and it's really annoying.

Re: I need suggestions please

Posted: Mon Nov 13, 2017 5:27 pm
by Catspit Productions
Okay so unless the mesh is completely hazy and gray, then the HR5 should do the trick.

Re: I need suggestions please

Posted: Tue Nov 14, 2017 7:03 am
by Meatsack
Ok sounds like a plan. I'll get some next paycheck

Re: I need suggestions please

Posted: Tue Nov 14, 2017 1:09 pm
by Catspit Productions
Good luck and let me know if I can help out anytime.